Главная Форумы Технический форум Вопрос / Ответ ++ Dana 60 crush sleeve install instructions #108#

В этой теме 0 ответов, 1 участник, последнее обновление  fzipdgnmgk 18.12.2018 в 04:29.

Просмотр 1 сообщения - с 1 по 1 (всего 1)
  • Автор
    Сообщения
  • #2504

    fzipdgnmgkУчастник
    • Offline

      Download >> Download Dana 60 crush sleeve install instructions

      .
      .
      .
      .
      .
      .
      .
      .
      .
      .

      dana 44 pinion preload

      dana 60 ring and pinion setup

      gm 10 bolt crush sleeve torque

      dana 44 ring and pinion installation instructions

      ford 9 inch crush sleeve installation

      dana 35 ring and pinion installdana 80 ring and pinion installation

      ford 8.8 crush sleeve eliminator install

      22 Sep 2015
      26 Jan 2016
      Please read all the instructions before beginning the installation. Ring Gear. Bolt. Cap. Dana. D30. 0.065″. 12. -15. 6. -8. 6-10. 55. 60. D30 JK . Slide the crush sleeve on the pinion shaft and install the pinion through the rear of the housing.
      Gear set up and installation should be performed by someone experienced in gear and axle set up. • Special tools sure the crush sleeve comes out with the pinion gear. 17. . Keep the vehicle at speeds below 60 mph for the first 100 miles.
      Installation Instructions for Dodge 2500/3500. View PDF . Hardcore Locking Hubs: Dana 60 – Install Manual Tech Tips: Crush Sleeves VS Preload Spacers.
      2 Apr 2018 Well the good news for you is rebuilding your Dana 60 Center section . use a socket on an air drill to spin the differential it by the pinion nut.
      have gathered information from Gleason gear design manuals, Dana .. solution that I know of is to install another new crush sleeve and start over.
      Tighten the pinion nut enough to take up the slack in the bearings. Place the pinion 10009 Dana 60 does not work on high pinion front axles. NOTE: 8.8 FordGleason gear design manuals, Dana Spicer instruction manuals, technical . 60. 7.5. » &. 7.6. » .0. 35. 12. -1. 5. 6-7. 6-1. 0. 3-6. 65. 60. 7.6. » IR. S. (1. 95 m m. ) .. Before setting the final pinion bearing preload, install the pinion seal, slinger (if

    Просмотр 1 сообщения - с 1 по 1 (всего 1)

    Для ответа в этой теме необходимо авторизоваться.